Get More From Your FLIR E4 and Other FLIR Thermal Cameras

15 Dec
2014

flir-e4-thermal-imaging-camera

Last year a workaround that included the modification of the software of the FLIR E4 entry level thermal camera has been discovered that allowed the users to get higher resolution and additional functionality available only in the top model of the series – the FLIR E8. It seems that the thermal imaging sensor used in the whole series was the same higher resolution one and it has been locked to lower resolution for the cheaper models from the series and the additional software features available in the higher-end models as well. FLIR has quickly addressed the “issue” by updating the firmware and selling new cameras with newer firmware version that did not allow the easy modification from users, but it seems that it might still be possible to unlock at least the resolution on E4 cameras with newer firmware. Meanwhile the “hack” was also extended to cover other models from the FLIR thermal camera range such as the FLIR i3/i5 that can be modified to i7 in terms of functionality or FLIR E30 to E60. If you are interested you can check the pretty long discussion with information and modification guides available on the EEVblog, but be warned that the process may not be easy for the average user as it involves some tinkering with the device and its software. If you are not sure you will be able to do it, then you better not even try as you may end up with unusable thermal camera that cannot be repaired under warranty, so be careful!

For more information on how to modify the FLIR E4 and other FLIR thermal cameras…



Other Similar Publications:

Leave a Reply

Your email address will not be published. Required fields are marked *

top